Peavey Max 450 - Manual (Page 6)

5 5.. P PO OW WE ER R//S ST TA AT TU US S LLE ED D
Located on front panel this LED illuminates green when the Power Switch is in the “ON” position and AC power is
supplied. During normal operation the LED also acts as a DDT indicator. The LED illuminates red when the DDT
speaker protection is active. When DDT is defeated, the LED will illuminate red when clipping occurs.
6 6.. IIN NP PU UT T JJA AC CK K
This input will accept signals from all types of bass pickups.
7 7.. IIN NP PU UT T P PA AD D S SW WIIT TC CH H
Provided for instruments that have extremely high output, which can result in overdriving (distorting) the input
stage. Pressing the switch to its “in” or “active” position reduces the level of the input signal by 10 dB.
8 8.. B BR RIIG GH HT T S SW WIIT TC CH H
Provides a preset boost to treble frequencies when pressed.
9 9.. T TU UN NE ER R S SE EN ND D JJA AC CK K
A 1/4" jack is provided for connecting an instrument tuner. This jack is buffered off the input jack so it is just like
plugging directly into the tuner.
110 0.. P PR RE E G GA AIIN N C CO ON NT TR RO OLL
Controls the input gain of the preamplifier.
1111.. C CO ON NT TO OU UR R C CO ON NT TR RO OLL
Provides a specially voiced EQ as the knob is rotated clockwise. When the knob is fully counterclockwise (set to
0), there is no voicing added.
112 2.. LLO OW W C CO ON NT TR RO OLL
An active tone control (shelving type, ±15 dB) that varies the low frequency boost or cut.
113 3.. M MIID D C CO ON NT TR RO OLL
An active tone control (peak/notch, ±15 dB) that varies the midrange boost or cut.
114 4.. M MIID D S SH HIIFFT T C CO ON NT TR RO OLL
Selects the frequency band (200 — 2 kHz) that the mid control cuts or boosts.
115 5.. H HIIG GH H C CO ON NT TR RO OLL
An active tone control (shelving type, ±15 dB) that varies the high frequency boost or cut.
6
9 18 17 19 20 23 25 26 21 22
6 7 10 8 11 12 13 14 15 16 5 24
F Frro on ntt P Pa an ne ell