Petsafe Stay+Play Wireless Fence PIF00-12917 - Manual (Page 11)

www.petsafe.net 11
Adjust the Pet Area to Desired Size
Make sure the entire Pet Area lies within your property
boundaries (4A). Always start determining the Boundary Zone
at the shortest distance from Transmitter. Place the Boundary
Switch on “Low” if the Boundary Zone will be less than 45 feet
from the Transmitter.
Test Light Instructions
1. Make sure the Receiver Collar Battery is properly charged.
Set the Correction Level to 2 or above.
2. Hold the Test Light Contacts to the Contact Points. (4B)
3. Walk toward the Boundary Zone holding the Receiver Collar
at your pet’s neck level (4E) until the Test Light flashes (4F).
Save Test Light for future testing.
Note: If your next-door neighbor has an In-Ground Containment
System, see Troubleshooting section page 23.
To maximize your Pet Area, make sure the Boundary Switch is on
“High” and the Boundary Control Dial is set to “8” (4C & 4D). Plug
Power Adapter into Power Jack and standard 120-volt outlet.
Pet
Area
STREET
4A
4B
Two-Person Method
Hold the Receiver Collar at your pet’s neck height (4E)
with logo side facing away from the Transmitter and
Contact Points facing upwards. Walk to the edge of
the desired Pet Area. Facing away from the Transmitter,
hold the Receiver Collar at the edge of the desired Pet
Area (4F).
Starting with the Boundary Control Dial set to “8”,
LOW
HIGH
4D
8
7
4C
have a second person turn the dial down SLOWLY. When the Receiver Collar starts to
beep, tell the person to stop turning the Boundary Control Dial. Record your settings on
the next page for future reference.
Step
4
One-Person Method
Measure the shortest distance from the desired
Boundary Zone to the Transmitter. Find the
distance on the Transmitter Range Chart on
the next page and set the Boundary Switch
and Boundary Control Dial. Hold the Test Light
Contacts to the Contact Points (4B). Take the
Receiver Collar to the Boundary Zone with the
logo side facing away from the Transmitter and
Contact Points facing upwards (4E). Hold the
4E
Bou
ndary
Zone
Pet
Area
4F
Receiver Collar at your pet’s neck level (4F) until the Receiver Collar beeps and the Test
Light flashes. If the Receiver Collar beeps before or after the desired Boundary Zone,
return to the Transmitter and adjust the Boundary Control Dial. Repeat this process
until the Receiver Collar is beeping at the desired location. Record your settings on the
next page for future reference.