Philips HTS3181 - Manual (Page 16)

16
Note
If distorted picture is displayed, turn off the •
progressive scan feature on this product and TV.
Change speaker settings
Ideally, the distance between listening position
and all the speakers should be the same. If not,
change the speaker settings based on their
distance from the listening position to obtain
the best possible surround sound.
1
Press DISC.
2
Press SETUP.
3
Press to select [Audio Setup] in the
menu, then press .
If the speaker setup option is not •
accessible, press twice before you
press SETUP.
To set the speakers level
1
Select [Speakers Volume] in the menu,
then press .
Speakers Volume
Speakers Delay
Night Mode
CD Upsampling
Audio Setup
Speakers Volume Setup
Front Left
Front Right
Center
Subwoofer
Rear Left
Rear Right
0dB
0dB
0dB
0dB
0dB
0dB
Turn on Progressive Scan
If the TV supports progressive scan output, you
can connect this Home Theater System and the
TV using component video connection. (see
‘Connect video cables’ > ‘Option 2: Connect to
the component video jack’).
1
Turn on the TV and ensure that the TV
progressive scan mode is deactivated (see
the TV user manual).
2
Switch the TV to the correct viewing
channel for this Home Theater System.
3
Press DISC.
4
Press SETUP.
5
Press to select [Video Setup] in the
menu, then press .
6
Select [Progressive] > [On], then press
OK.
A warning message is displayed.
»
7
To proceed, select [Ok] and press OK.
The progressive setup is complete.
»
Note
If a blank/distorted screen is displayed, wait for •
15 seconds for the auto recover.
If no picture displayed, turn off the progressive
•
scan mode as follows: 1) Press to open
the disc compartment. 2) Press . 3) Press
AUDIO SYNC.
8
Press SETUP to exit the menu.
9
You can now turn on the progressive scan
mode on the TV.
Video Setup
Picture Settings
TV Display
TV System
Progressive
On
Off
EN