Philips HTS3181 - Manual (Page 36)

36
Sound
No sound.
Make sure that the audio cables are •
connected and select the correct input
source (for example, AUDIO SOURCE,
USB) for the device you want to play.
If this Home Theater System does not
•
support DTS surround sound, ensure that
the play source is not from DTS audio
stream.
No sound from TV program.
Connect an audio cable from the AUDIO •
input on this Home Theater System to
the AUDIO output on your TV. Then
press AUDIO SOURCE repeatedly to
select the corresponding audio input
source.
No surround sound effect from the speakers.
Press • SURR to select a correct surround
sound setting.
If the Home Theater System supports
•
DTS playback, press AUDIO SYNC to
select other audio track.
Ensure that the source you are playing is
•
recorded or broadcast in surround sound
(Dolby Digital, etc).
10 Troubleshooting
Warning
Risk of electric shock. Never remove the •
casing of the product.
To keep the warranty valid, never try to repair
the product yourself.
If you have problems using this product, check
the following points before you request service.
If you still have a problem, register your product
and get support at www.philips.com/welcome.
If you contact Philips, you will be asked for the
model and serial number of your product. The
model number and serial number are on the
back or bottom of your product. Write the
numbers here:
Model No. __________________________
Serial No. ___________________________
Main unit
The buttons on this product do not work.
Disconnect this product from the power •
outlet for a few minutes, then connect
again.
Picture
No picture.
See TVs manual for correct video input •
channel selection. Change the TV channel
until you see the DVD screen.
Press
• DISC.
If you have changed the • [TV System]
setting, switch back to default mode: 1)
Press to open the disc compartment. 2)
Press . 3) Press SUBTITLE.
EN