Philips DC200/93 - Manual (Page 7)

5 Press PROG/SET TIME to confirm.
6 In clock mode, press ALBUM/PRESET -/+ 1 /2 to set your time zone.
7 To zoom in/out the clock display, press MODE in clock mode.
TUNER
1 Press SOURCE repeatedly to switch on the radio (FM only).
™ Display shows the radio frequency of the last selected waveband.
Your preset station is also shown if you are listening to a preset. (See 2)
2 Adjust the sound using VOLUME 3 /4.
3 To select preset stations, press ALBUM/PRESET -/+ 1 /2 once or repeatedly.
TUNING TO RADIO STATIONS
1 Press and hold ¡1 / 2™ until the frequency in the display starts changing.
™ After the system tunes to a station of sufficient reception, display shows
its frequency.
• To tune to a weak station, press ¡1 / 2™ briefly and repeatedly until an
optimal reception is found.
To improve reception (FM):
Extend and position the pigtail fully to obtain optimum reception.
STORING AND USING PRESET STATIONS
You can store up to 20 FM radio stations in the memory.
1 Tune to your desired station (see TUNING TO RADIO STATIONS).
2 Press PROG to activate the programming, and then press ALBUM/
PRESET -/+ 1 / 2 to select a desired preset number.
3 Press PROG again to confirm.
4 Press ALBUM/PRESET -/+ 1 / 2 to listen to a preset station.
AUTOSTORE: Automatic programming
1 Press and hold PROG for more than two seconds.
™ Available radio stations will be automatically stored.
CAUTION
High voltage! Do not open.You run the risk of getting an electric
shock. The machine does not contain any user-serviceable parts.
Modification of the product could result in hazardous radiation
of EMC or other unsafe operation.