Precor Low Impact Climber with Pulse 718e - Manual (Page 10)

Page 10
1
3
2
4 5
5. Attach Resistance Cylinders to Upright Support. (Diagram 8) Remove the
bolt, washer and spacer from the upper axle using your fingers or the hex
key (G) provided. With the indicator arrow facing toward the footpad, slide
the top of the resistance cylinder onto the upper axle. Place the washer and
spacer on the bolt. Re-insert the bolt and tighten securely using the hex
key provided. Repeat this same step to attach the other resistance cylinder.
Adjustment portion
Upright support
Indicator arrow
Resistance cylinder
Diagram 8
Attach resistance cylinder to
upright support
Bolt
Washer
Spacer
Upper axle
Diagram 9
Remove bolts from lower
resistance cylinder mounts
6. Connect Resistance Cylinders to Stair Arms. (Diagrams 9 and 10) The
washers, nut, and bolt need to be removed from the lower resistance
cylinder mount (U-shaped mount) before connecting the resistance
cylinders. See Diagram 9. Remove the bolt using your fingers or the
supplied hex key (G). To mount the lower resistance cylinders to the stair
arms, take the following steps:
Note: Perform the following steps on one stair arm at a time.
U-shaped mount
Stair arm
Bolt
Washer
Nut