Precor Low Impact Climber with Pulse 718e - Manual (Page 11)

Page 11
Diagram 10
Attach resistance cylinder to stair arm
Bolt
Stair arm
Nut
a. Align the resistance cylinder with the holes in the U-shaped mount
and slide the resistance cylinder into position. See Diagram 10.
b. Insert the bolt through the U-shaped mount and resistance cylinder as
shown in Diagram 10. Use the wrench to hold the nut in place while
you tighten the bolt securely.
c. Repeat step 6 to mount the other resistance cylinder.
Resistance cylinder mount
Washer
Bushing
U-shaped mount
Diagram 11
Install handrail
Handrail console
Handrail
Upright support
CAUTION: The reed switch
cable should slide easily
through the upright support.
Do not tug on the cable
because you could void the
manufacturer’s limited
warranty. 7. Install Handrail. (Diagram 11) Take the two small bolts from the hardware
kit. Position the handrail console (flat surface of the console should face
up) on top of the upright support and feed the reed switch cable through
the large hole in the handrail console. Tape the connector to the top of the
console. Align the bolt holes and secure the handrail console to the frame
by inserting the bolts through the top of the handrail console and into the
upright support. Tighten the bolts firmly using the hex key (G).
Important: Pull gently on the excess cable as you feed the cable through
the large hole in the handrail console. If the cable does not move freely,
check to be sure that the cable is not pinched or crimped between the long
and short column mounts. See step 3.
Bolt
Reed switch cable