Precor 5.23 - Manual (Page 45)

Owner’s Manual: Advanced Programming and Troubleshooting 43
Selecting a U.S. Standard or Metric
Display
The EFX can display measurements in either U.S. Standard
(U.S. STD) or METRIC. The default factory setting is set to
display U.S. STD. To change this setting, perform the
following steps:
1. At the Precor banner, press the following keys in
sequence and without pause:
RESET, QUICKSTART, ENTER, SELECT [USER 2],
CROSSRAMP
▲
Note: No CROSSRAMP keys exist on the EFX5.33. Use
the RESISTANCE
▲ key on the left side of the keypad.
As shown in Diagram 10, numbers are associated with
the keypad. The numbers 5, 6, 7, 1 appear on the display
as you press the associated key.
Diagram 10: Keypad programming numbers
2. SELECT UNITS appears, followed by the current unit of
measure (U.S. STD or METRIC). Use an arrow key to
switch between the options.
3. Press ENTER to accept the displayed setting.
The change will be retained in memory even if the EFX is
turned OFF and unplugged.
4. Press RESET to return to the Precor banner.
EFX5.23
EFX5.33
1
4
5 3 7 6
8
9
2
1
4
5 3 7 6
8
9
2
EFX_Owners Manual.book Page 43 Friday, June 16, 2006 9:25 AM