Panasonic CW-XC122VU - Manual (Page 6)

5
AIR CONDITIONER OPERA
TION
6
PR
ODUCT SPECIFICA
TIONS
Model CW-XC122VU
COOLING CAPACITY Btu/h 11,500
ELECTRICAL RATING Phase Single
Frequency (Hz) 60
Voltage (V) 115
Current (Amps) 10.1
Input (W) 1150
EER (Btu/W.h) 10.0
MOISTURE REMOVAL (Pints/h) 3.0
ROOM AIR CIRCULATION (Cf/min) 330
DIMENSIONS Height cm (inches) 37.5 (14- 25 /
32
˝)
Width cm (inches) 56 (22- 1 /
16
˝)
Depth cm (inches) 60.6 (23- 27 /
32
˝)
NET WEIGHT kg (lb) 35 (77)
GROSS WEIGHT kg (lb) 39 (86)
NOISE LEVEL Indoor (Hi/Lo) dB (A) 51/47
Outdoor (Hi/Lo) dB (A) 58/55
ECONOMY OPERATION
To reduce power consumption:
• Press ECONOMY.
• To cancel this operation, press once
more.
ECONOMY
Recommended for electricity cost saving. When economy button
is pressed, target temperature is shifted up 1°F, this will reduce
operating time of the compressor and therefore reduce power
consumption. It may, however, take a little longer for the
compressor to cycle on and thereby increase the room
temperature slightly. Economy mode will override your current
set fan speed to “LOW”. However, the display will still show the
current set fan speed. Compressor stops when the room
temperature reaches the target temperature. It turns on again
when the room temperature rises. When power failure occurs,
the economy setting is canceled. Once power is resumed, reset
the economy setting.
SETTING THE OFF TIMER
When the air conditioner in operation:
Press the TIMER button.
The SET/CANCEL indicator light will
blink awaiting for setting.
Press the TEMP/TIMER
▲ or ▼ button
until the preferred hour of operation is
reached.
Press the SET/CANCEL button to
complete the setting. At this time, the
SET/CANCEL indicator light is steady
instead of blinking.
NOTE
The hour reading will change back to the
set temperature reading after 10
seconds. (You can also revert to
temperature setting immediately by
pressing the TEMP/TIMER
▲ or ▼
buttons again.)
CHECK TIMER SETTING DURING OFF TIMER
Press the TIMER button to check the
remaining programmed timer setting.
The figure will be displayed for 10
seconds then will automatically switch
back to temperature setting.
NOTE
The timer figure will change according
to the time remaining (if you set it to turn
off 3 hours from now, the timer will show
“2” at an hour later).
CANCEL TIMER SETTING DURING OFF TIMER
Press the SET/CANCEL button to
cancel the timer setting. The SET/
CANCEL indicator light will turn off.
However the temperature remains
displayed.
ECONOMY
TIMER
TEMP/TIMER
SET
SET/
CANCEL
TIMER
SET
SET/
CANCEL
ECONOMY
TIMER
TEMP/TIMER
SET/
CANCEL
TIMER
SET/
CANCEL
hr
° F
hr
° F
hr
° F
hr
° F
hr
° F
hr
° F
hr
° F
* Specifications are subject to change without notice for further improvement.