Panasonic UB-5838C - Manual (Page 22)

Scanning
22
Note
• The use of a USB hub is not recommended.
We cannot guarantee that the unit will work
properly.
• Do not connect two or more Panasonic
electronic boards to a computer. It may cause
the computer operation to become unstable.
3 Press the Mode Key to select the
scanning mode.
4 Press the Start/Stop Key.
• The unit starts scanning.
• The scanning status is shown on the display.
• When scanning has finished, a preview of the
scanned image is shown on the display.
Note
• Do not remove the USB cable until the
scanned image file has been completed
copied to the computer.
5 Open the Removable Disk displayed on the
computer screen, and click [Refresh] from the
[View] in the Windows Explorer window.
• The scanned image file is shown on the
display.
6 Copy the image file in the Removable Disk onto
the computer’s desktop or into a folder.
Note
• It is possible to save a maximum of 2 scanned
images to the electronic board’s removable
disk.
If a third image file is scanned with the
electronic board, the first image file will be
deleted.
• The scanned image files will be deleted if the
USB cable is removed.
7 Press the Advance Key ( ) to zoom in on the
image with the electronic board.
• It is possible to view specific areas of the
image.
• The current view area is shown on the top left
side of the display.
Press the Set-up Key (
) to move down.
Press the Advance Key ( ) to move left.
• Press the Mode Key (
) to return to the
preview.
8 Press the Mode Key ( ).
• The Screen Erase Announce is shown on the
display.
9 After erasing the written text/diagrams on the
screen, press the Mode Key (
) to return to
standby mode.
• Only remove the USB cable once you have
returned to standby mode.
Perform the following steps when removing
the USB cable:
1) Right-click the [Safely Remove Hardware]
icon in the taskbar notification area in the
bottom-right corner of the display.
(In Windows 2000, the icon is entitled
[Unplug or Eject Hardware].)
2) When the list of devices is displayed, click
the device to remove, and then click the
[Stop] button.
3) Remove the USB cable connected to the
computer from the electronic board.
• For information on saving files on a computer,
refer to page 17.
UB5838C-PJQXC0259ZA_mst.book 22 ページ ２００９年５月２６日 火曜日 午後２時５９分