Pentair Side Pool Cleaner - Manual (Page 10)

LEGEND® PLATINUM INSTALLATION MANUAL
E. Cutting the Feed Hose - (cont.)
8. When cutting hoses, please use strong scissors
or a sharp knife. Be sure to slide the floats out of
the way when cutting hose.
9. Put extra mender nut on the Legend ® Platinum
mast and push soft hose gently over mast at
1/2 in., turn mender nut around soft hose tight.
Note: The Back-Up Valve still should be 30 in.
from the head of the cleaner.
FEED HOSE
MENDER NUT FEED MAST
SWIVEL
10. Now take the bag, EU16, out of the box and firmly
twist lock the bag onto the top of the Legend ®
Platinum throat over rubber debris valve.
11. Review and check list: Hoses cut properly and
floats evenly spaced. Mender nuts tight around
swivels, back up valve, Legend
® Platinum mast
and wall fitting. Make sure wall fitting is securely
locked into place.
12. Lower your complete Legend ® Platinum
assembly into your pool carefully. It should look
like figure below.
13. Go back to your equipment and turn filter pump
on first (wait 30 seconds to force air out of the
hose), then turn booster pump on.
14. For large pools requiring more hose length you
will need to purchase one (1) additional hose
(LLD45-White or LLD45PM-Gray), four (4) floats
(ED10P-White or LLD10PM-Gray), one (1) swivel
(ED05-White or LLD05PM-Gray), and two (2)
mender nuts (ED15-White or LLD16PM-Gray).
Attach extra hose between long hoses using
floats, swivel and mender nuts. Divide extra hose
overage by three (3) this time to keep all hoses
the same length.
FIRST
SWIVEL SECOND
SWIVEL
THIRD
SWIVEL
SHORT
WHITE
HOSE
LONG
WHITE
HOSE LONG
WHITE
HOSE
BACK UP
VALVE
CLEAR
HOSE
6