Pentair Side Pool Cleaner - Manual (Page 8)

LEGEND® PLATINUM INSTALLATION MANUAL
4
7½ FT.
EXAMPLE DIMENSION
(Your Measurement May Differ)
NOT TO SCALE
MARKED SWIVEL
FARTHEST POINT OF POOL PERIMETER
FROM WALL FITTING
STEPS
1. With the feed hose assembly attached to the pool wall, hold the feed hose assembly
by the opposite end with the clear hose and walk the perimeter of the pool to locate
the farthest point on the perimeter from the wall fitting without stretching the hose assembly.
2. Measure the distance that the hose assembly extends beyond the pool perimeter
farthest point located in Step 1 — (7½ ft. in this example).
3. Cut half of the length obtained from Step 2 — (3¾ ft. in this example),
equally from each of the 10 foot lengths of white or grey hose on either
side of the marked swivel.
10 FOOT
WHITE OR GREY
HOSE SECTION
10 FOOT
WHITE OR GREY
HOSE SECTION
10 FOOT
SOFT HOSE
BACK UP
VALVE
REMOVE EXCESS MATERIAL
FROM HOSE ON EITHER SIDE OF
MARKED SWIVEL AS DESCRIBED
IN STEPS 2 AND 3.
WALL FITTING
SWIVEL
SWIVEL
FLOATS
FLOATS
FLOATS
EXAMPLE OF HOSE ASSEMBLY
BEFORE CUTTING TO LENGTH
EXAMPLE OF FINISHED HOSE ASSEMBLY
AFTER CUTTING TO LENGTH
WHITE OR GREY
HARD HOSE SECTION
MARKED SWIVEL
END OF
SOFT HOSE
(End remains 30 in.)
SOFT HOSE
(Cut to your pool depth)
BACK UP VALVE FURTHEST POINT
OF POOL PERIMETER
FROM WALL FITTING
STEPS
4. Reassemble the hoses using the supplied mender nuts
as shown in FIGURE 1.
5. Your complete finished hose assembly should look like this.
The end of the 30 inch clear hose should reach just to the
furthest edge of the pool perimeter as shown.
WHITE OR GREY
HARD HOSE SECTION
FIGURE 1
WHITE OR GREY
HARD HOSE SECTION
(WALL FITTING SIDE)
WHITE OR GREY
HARD HOSE SECTION
(CLEANER SIDE)
MARKED SWIVEL