Troubleshooting, Common, Radio – Panasonic CQ-C1301U User Manual

Page 18: Disc player, Error display messages

Advertising
background image

Troubleshooting

Trouble

Check point

No power

Start the engine. (Or turn the ignition
switch to the ACC position.)

Verify the wiring. (battery lead, power
lead, ground lead, etc.)

Fuse blown (Contact the nearest
Panasonic Servicenter.)

Ask a professional for fuse replacement.

Be sure to use the same rated fuse.

No sound

Disable the mute function.

Verify the wiring.

Wait until the dew disappears before
turning on the unit.

Noise

Make sure that grounding is established
properly.

Common

Frequent

noise

Tune in to another station of high-inten-
sity waves.

Make sure that the antenna mounted
point is grounded properly.

Radio

Preset data

deleted

The preset memory is cleared to return
to the original factory setting when the
power connector or battery is discon-
nected.

No sound, or disc

is automatically

ejected

Load the disc correctly.

Clean the disc.

Disc Player

Sound skip,

poor sound

quality

Clean the disc.

Sound skip

due to

vibration

The maximum permissible tilt angle is
30°.

Secure the unit.

Disc

unejectable

Press [

u

]. If the disc is still not ejected,

contact the nearest Panasonic
Servicenter.

No sound from

left, right, front,

or rear speaker

Adjust the balance and fader.

Verify the wiring.

Trouble

Check point

Left and right

sounds are

reversed

Connect the speaker lead correctly.

Error Display Messages

(The disc is ejected automatically.)
The disc is dirty, or is upside down.

Check the disc.

(The disc is ejected automatically.)
The disc has scratches.

Check the disc.

No operation by some cause.

If normal operation is not restored, con-
sult your dealer or the nearest
Servicenter to ask for repairs.

Cannot read the file

Check the file.

A WMA file can be copyrighted.

The file protected by copyright is not
playable.

No disc is in the CD Changer (maga-

zine).

Cannot receive XM Satellite Radio.

Verify the wiring.

DIN cord is disconnected.

Connect the DIN cord.

Channel not in service

This channel is not currently in
service. Tune to another channel.

Note: Messages in the action and display sections of the error chart
vary with changers. Refer to the operating instructions for the CD
changer for details.

CQ-C1401U

CQ-C1401U

If You Suspect Something Wrong

Check and take steps as described below.
If the described suggestions do not solve the problem, it is recom-
mended to take the unit to your nearest authorized Panasonic
Servicenter. The product should be serviced only by qualified person-
nel. Please refer the checking and the repair to professionals.
Panasonic shall not be liable for any accidents arising out of neglect
of checking the unit or your own repair after your checking.

Warning

¡ Do not use the unit in an irregular condition, for example, with-

out sound, or with smoke or a foul smell, which can cause
ignition or electric shock. Immediately stop using the unit and
consult your dealer.

¡ Never try to repair the unit by yourself because it is dangerous

to do so.

Advertising