Panasonic WV-BP550 - Manual (Page 28)

-26-
5. The VS gen-lock mode has its own menu for hori-
zontal phase adjustments. When the cable length
of the video output or the gen-lock input is
changed, the horizontal phase must be re-adjust-
ed.
6. The line-lock mode has its own menu for line-lock
vertical phase adjustment. If the camera installa-
tion is relocated, check the vertical phase adjust-
ment again since the AC line phase may be differ-
ent.
6-1. VS Gen-lock Mode (EXT(VS))
1. Move the cursor to the SYNC parameter and
select INT.
2. Connect the coaxial cable for the composite sync
or composite B/W video signal to the gen-lock
input connector.
3. Confirm that the parameter INT changed to EXT
(VS) on the menu.
Caution: The gen-lock input signal should meet
with EIA RS-170 specifications and should not
contain jitter, such as a VCR playback signal ,
as it could disturb synchronization.
4. After confirming the cursor is on EXT (VS), press
. The phase adjustment menu appears on the
monitor.
** CAM SET UP **
CAMERA ID OFF
ALC/ELC ALC
SHUTTER ---
AGC ON
SENS UP OFF
SYNC INT
MOTION DET OFF
LENS DRIVE DC
END SET UP ENABLE
↵
↵
↵
** CAM SET UP **
CAMERA ID OFF
ALC/ELC ALC
SHUTTER ---
AGC ON
SENS UP OFF
SYNC EXT(VS)
MOTION DET OFF
LENS DRIVE DC
END SET UP ENABLE
↵
↵
↵
** SYNC **
H PHASE ........I
- +
RET END
5. Move the cursor to H PHASE. The cursor starts
blinking.
6. Supply the video output signal of the camera to be
adjusted and the reference gen-lock input signal
to a dual-trace oscilloscope.