Panasonic WV-BP550 - Manual (Page 30)

-28-
(FINE adjustment can be made up to 22.5 degrees
by pressing
or .)
Notes:
• When the “I” cursor reaches the “+” end, it
jumps back to “
−
”. At the same time, COARSE
is incremented by one step to enable a contin-
uous adjustment. The reverse takes place
when the “I” cursor reaches the “
−
” end.
• When or is kept pressed for a second
or longer, the “I” cursor moves faster.
• To reset COARSE and FINE to the values pre-
set at the factory, press or simultane-
ously. COARSE and FINE adjustments are
preset at the factory to zero-crossing of the
AC line phase.
• If the AC line contains noise (spike noise,
etc.), the stability of the vertical phase of the
camera video output signal may be disturbed.
7. Motion Detector Setting (MOTION DET)
The motion detector detects the moving objects in the
scene by monitoring the brightness level changes. You
can select the level of sensitivity for motion detection.
When this camera is connected to a compatible intelli-
gent CCTV system, the camera transmits an alarm sig-
nal by multiplexing it with the video signal.
1. Move the cursor to the MOTION DET parameter
and select ON.
2. Press . The MOTION DETECT menu appears
on the monitor screen.
3. Move the cursor to MASK SET and press . The
MASK SET menu has 48 masks. To set MASK SET,
proceed as described in steps 2 to 4 of “ALC
mode with SUPER-D OFF and ELC mode” on page
22.
4. Move the cursor to the ALARM parameter and
select ON or OFF to set the alarm in the DISPLAY
MODE.
Note: When the system controller WV-RM70, WV-
CU550 or WV-CU550A is used with this
model, select OFF for ALARM.
5. Move the cursor to DISPLAY MODE and press
to see the current setting. The masks that detect
the brightness changes start blinking.
** CAM SET UP **
CAMERA ID OFF
ALC/ELC ALC
SHUTTER ---
AGC ON
SENS UP OFF
SYNC INT
MOTION DET ON
LENS DRIVE DC
END SET UP ENABLE
↵
↵
↵
** MOTION DETECT **
LEVEL ....I....
- +
DISPLAY MODE
ALARM ON
MASK SET
RET END
↵
↵