Paxar Handi Print 6017 - Manual (Page 21)

Cleaning 4-1
C L E A N I N G
You may need to clean the printhead
and platen roller after printing
approximately six rolls of supply,
whenever you load new supplies, or
when you see voids in the print as
shown.
CAUTION
Do not use sharp objects to clean the
printhead. This may damage the
printer and require a service charge.
1. Open the supply cover by inserting your fingers into
the rubber pull tab and pulling up firmly on the supply
cover.
2. Remove the supply roll (when cleaning the
printhead).
3. Moisten a cotton swab with isopropyl alcohol and
clean the printhead as shown.
4
Printhead