Connecting the printer to a computer, P. 49), Setup – Panasonic KX-PS8000 User Manual
Page 49
49
Setup
Note for Terminator setting:
B
The printer must be the last device in the chain. The terminator setting of all
other devices in the chain must be off.
■
Using a SCSI cable:
Make sure the computer, printer and the other connected
peripheral devices are turned off.
Connect the SCSI cable to the computer’s SCSI connector and
the printer’s SCSI connector.
B
A SCSI-2 board must be installed in the computer.
If you do not have a SCSI-2 board or a SCSI interface cable, you will need to
purchase one from your local computer store or dealer
Make sure the SCSI ID No. of the printer is 1 (default setting).
B
If you have other devices connected to the computer, make sure that each
SCSI device has different ID No.
B
To change the printer’s ID No., use the ID No. switches (#1, #2, #3) located
on the back of the printer. Also refer to Table 1 on
1
2
3
Connecting the Printer to a Computer
12
3
4
ON
Computer’s
SCSI connector