Panasonic DP-C266 - Manual (Page 10)

10
Precautions
Handling
„ Control Panel
Do not lift or lean against the Control Panel. The Control
Panel can be broken which could result in injury.
„ Power Switch
z Used to turn ON or OFF the Main Power Switch on the
rear side of the machine and to turn ON or OFF the
Power Switch on the front side of the machine.
Follow this procedure when turning OFF the Main
Power of the machine:
- Turn OFF the Power Switch on the front side of the
machine, wait a few seconds, and then turn OFF the
Main Power Switch on the rear side of the machine.
z If you are not going to use the machine for long periods
of time, turn OFF the machine using the procedure
above.
z Do not turn OFF the Power Switch on the front side of
the machine, or open the Front Cover during copying/
printing.
„ Auto Reset Time
The initial setting for Auto Reset Time is 1 minute.
If you do not touch any key for 1 minute, the Touch Panel
Display will return to the initial screen of the active function
automatically. When reaching 20 seconds before
resetting, the “Continue?” screen is displayed to allow you
to extend the auto reset time for another 1 minute.
If you wish to change the Auto Reset Time, consult with
your Key Operator.
„ Dept. (Department) Code
When the Department Counter function is set up, the
Dept. (Department) Code input screen is displayed on the
Touch Panel Display. A registered Department Code (1 to
8 digits) is required to gain access to each secured
function, or the secured Copy/Facsimile/Internet Fax
function(s) cannot be used. Please consult with the Key
Operator regarding the Department Code(s) for the
desired function.
How to enter the Dept. Code:
1 Input a registered department code (1 to 8 digits).
2 Select “OK”.
„ Maximum Copies Limitation
After setting the maximum allowed number of copies for
each department, consult with your Key Operator when
the total copy count reaches the designated limit and the
message appears on the Touch Panel Display.
„ Auto Image Density/Color Registration Adjustment
Functions
This machine executes the following automatic adjustment
periodically (approximately every 105 copies or print jobs).
During the automatic adjustment process, copy job/print
job will stop or jobs will be waited approximately 20
seconds.
(1) Auto Image Density
To adjust the print density even.
(2) Color Registration Adjustment
To adjust the color registration.
„ Energy Saver (Power Save Mode, Sleep Mode)
You can set the machine to the Power Save mode or
Sleep mode while the machine is not in use. In Power
Save mode/Sleep mode, the Energy Saver key flashes or
lights. Press the Energy Saver key to return the machine
to its former operating screen. For more details, refer to
General Settings (Key Operator Mode) in the Operating
Instructions (For Function Parameters) of provided CD-
ROM.
z It is normal operation that the machine makes sounds
when switching into the Power Save mode.
z The machine enters the Sleep mode without entering the
Power Save mode if the Sleep mode and Power Save
mode are set to the same time, or the Sleep mode is set to
the shorter time than the setting for the Power Save mode.
z Press the Energy Saver key while the machine is in the
Sleep mode.
Main Power
Switch (Rear
Side)
ON ( )
OFF ( )
Power Switch
(Front Side)
ON ( )
OFF ( )
Modes Warm Up Time
Power Save Mode Approx. 15 sec.
Sleep Mode Approx. 15 sec.
Energy Saver key
Flashes: Power Save Mode
Lights : Sleep Mode
(Touch Panel Display
will be unlit.)