Panasonic DP-C266 - Manual (Page 26)

26
User (U) / Jam (J) / Machine (E) Error Codes
User Error Codes (U Codes) / Machine Error Codes (E Codes)
NOTE*
A. When the Maintenance and Toner/Toner Waste Container Indicators are blinking
The machine will complete the current job and stop operating. To continue using the machine temporarily while waiting for a
replacement toner/container, press any key. (Ex: For Toner Waste Container, approximately 400 additional copies can be
made.)
B. When the Maintenance and Toner/Toner Waste Container Indicators light up
The machine stops and will not allow further operation until the Toner Waste Container is replaced.
z When a user error occurs, the location and the procedures for
handling the user error are displayed frame by frame on the
Touch Panel Display. Check the location and handle the user
error according to the displayed pictures. Refer to the Operating
Instructions (For Maintenance) of provided CD-ROM.
Ex: Front Cover
is opened.
Ex: Toner Waste
Container is almost full.
Ex: Toner Waste
Container is full.
User Error (Locations)
Error Location Indicator
<Inner>
Toner Cartridges
(Yellow/Magenta/Cyan/Black)
Toner Waste Container
OPC Drum Units
(Yellow/Magenta/Cyan/Black)
<Outer>
ADF Cover
Finisher Top
Cover (Option)
ADF
(Automatic Document Feeder)
Section
Transport
Cover
(Option)
Battery
Holder
Front Cover
Right Side
Cover
Feed Cover 1
ADU Cover
Feed Cover 2
Option Feed
Cover
z Select “Close” to
continue the current
job temporarily. z Machine will stop.
Replace the Toner
Waste Container.
E Codes:
Call the authorized Panasonic dealer when
machine Error Code (E Code) appears on the
Touch Panel Display.
Code Check Points
U1 Front Cover is open.
U4 Finisher is pulled out.
U6 ADU Cover, Feed Cover 1, and/or Right
Side Cover is open.
U7 Feed Cover 2 & Option Feed Cover are
open.
U8 Transport Cover is open.
(When optional Paper Transport Unit is
installed)
U11 Paper remains in the Finisher Bin.
(When optional Finisher is installed)
U12 Finisher Top Cover and/or Staple Cover is
open.
(When optional Finisher is installed)
Code Check Points
U13* Toner level is low, or has run out.
(See page 15)
U14* Toner Waste Container is full.
(See page 15)
U15 Toner Waste Container is not installed.
U20 ADF Cover is open.
U21 ADF is open while scanning from ADF.
U25 Toner is hardened. Shake Toner Cartridge
well.
U28 OPC Drum Unit is not installed.
U29 OPC Drum Unit requires replacement.