Panasonic AJ-D92P - Manual (Page 39)

39
<Notes>
O
When the beginning or end of the tape has been
detected in the VTR operation mode, BOT
(beginning of tape) or EOT (end of tape) is
displayed at the beginning of the line.
Examples of what is displayed:
EOT STOP
(stop mode at end of tape)
BOT STANDBY OFF
(standby mode at beginning of tape)
O
In the T&S&R mode, one of the following error
displays appears on the third line (line where the
amount of remaining tape is displayed).
[NO RF]:
This appears when a blank section has been
detected on the tape.
At the same time, error code “E-09” and the
warning display “RF” appear on the status
display window.
[SERVO NOT LOCKED]:
This appears when the servo is not locked.
At the same time, error code “E-00” and the
warning display “SERVO” appear on the status
display window.
[LOW RF]:
This appears when there is no head output.
At the same time, error code “E-01” and the
warning display “RF” appear on the status
display window.
[HIGH ERROR RATE]:
This appears when the error rate has
deteriorated (when the 3 channel condition
indicators are lighted).
At the same time, error code “E-02” and the
warning display “RF” appear on the status
display window.
Operation modes
What is to be displayed on the screen can be selected
by setting setup menu item No. 003 (DISPLAY SEL).
(See page 45)
TIME: Counter value
T&STA: Counter value, VTR operation mode
T&R:
Counter value, amount of remaining tape
T&S&R: Counter value, VTR operation mode,
amount of remaining tape
Superimposed Screens
Counter value
TIME mode
TV monitor
Counter value
T&STA mode
TV monitor
VTR operation mode
Counter value
T&S&R mode
TV monitor
VTR operation mode
Counter value
T&R mode
TV monitor
Amount of remaining tape
Amount of remaining tape