Panasonic DM0706SY0 - Manual (Page 2)

–
2
–
Battery charge
Range/Distance (“No link to base.”)
Why call waiting
does not work when
I press {RECALL}?
L
You may be required to change the recall time to “90ms”.
(Default: “100ms”)
L Make sure you have subscribed to the call waiting service.
Consult your service provider/telephone company.
Question Cause & solution
How do I charge the
battery?
L
Make sure that the battery is properly installed in the handset
and the cover is closed. Place the handset on the base unit or
charger and confirm “Charging” is displayed.
L
It takes approx. 7 hours to charge the empty battery (see front
page). When it is fully charged, “Charge completed” is
displayed.
Can I leave the
handset on the
base unit or charger
after battery is fully
charged or each
call is finished?
L
You can place the handset on the base unit or charger
anytime. Battery is not overcharged and there is no damage
to the battery. By placing the handset on the base unit or
charger, it is always fully charged.
Where can I buy
new battery? L Battery can be purchased through your local retailer.
Question Cause & solution
What is the range/
distance of my
cordless phone?
(Why am I getting
short or poor range/
distance on my
cordless phone?)
Why is “No link
to base.”
displayed on the
handset when I
press {C}?
L
Range/distance is related to technology and environmental
factors. Therefore we cannot provide a given range or
distance.
L
Make sure that the AC adaptor is properly connected to wall
socket and to the base unit and that beep tones sound when
you page the handset from the base unit.
L Move closer to the base unit (Allow up to 60 seconds for the
handset to reassign to the base unit.).
L
If you try manual registration process, allow up to 60 seconds
for the handset to reassign to the base unit.
L If the above remedies do not solve the problem, refer to the
troubleshooting section in your Operating Instructions for
more information.
Question Cause & solution
TG6700AL_FAQ_Leaflet.fm Page 2 Monday, May 15, 2006 4:33 PM