Philips XP AJ 3430 - Manual (Page 9)

9
English
GENERAL
Two different alarm times can be set. This can be useful when
you need to be woken up at a different time e.g. during the
week and at the weekend:
• ALARM 1 – radio mode
• ALARM 2 – buzzer mode. The gentle wake buzzer alarm
increases its beep tone frequency within seconds.
SETTING THE ALARM TIME AND MODE
1. Turn the SET control to ALARM 1 or ALARM 2.
™ Display shows the alarm time digits with the
or indicators flashing.
2. Press 7 repeatedly or hold down on the button to adjust the
hours.
Release
7 when you reach the correct hour.
3. Press 8 repeatedly or hold down on the button to adjust the
minutes.
Release
8 when you reach the correct minute setting.
4. Turn the SET control back to CLOCK.
5. While the radio is switched off, select your choice of alarm
mode by pressing ALARM 1-RADIO or ALARM 2-BUZZER.
™ Display shows
or .
Notes: If you have selected the ALARM 1 RADIO, make sure
you have properly tuned to a station before turning off
the set.
If you set and activate the same alarm time for both
alarms, only the ALARM 2-BUZZER will be activated at
the set time.
SWITCHING OFF THE ALARM
There are three ways of switching off the alarm. Unless you
cancel the alarm completely, the 24 hour alarm reset option
will be automatically selected after 59 minutes, from the time
your alarm time first goes off.
24 hour alarm reset
If you want the alarm mode to be stopped immediately but
also wish to retain the same alarm setting for the following
day:
• Press ALARM RESET/ RADIO OFF.
™ You will hear a beep tone confirming 24 hour reset
activation.
USING THE ALARM
XP AJ 3430/17 08-05-2000 15:29 Pagina 9