Panasonic KX-T7565 - Manual (Page 245)

Customising Your Phone & System
User Manual 245
4.3.5 Flexible CO Button Assignment (005)
You can change the flexible CO buttons of all PTs in the system to the function buttons listed on the
next page. For example, if someone's telephone has more CO buttons than available CO lines, you
may change an unused CO button to a One-Touch Dialling button.
Default: For all PTs – CO button 1 = Loop-CO; Ring tone type 2
Other CO buttons = Not Stored
• The number of CO buttons available for each PT varies depending on the telephone type.
To programme 24 CO buttons, please use both the PT with 12 CO buttons (such as the KX-
T7536) and KX-T7545.
• If you press the same CO button twice consecutively during <Programming>, you can
select a desired ringer frequency for the CO button from eight types of ring tones. When
you enter the tone type number (1 through 8), you will hear the selected tone type until
STORE is pressed. This selection is possible only for the CO buttons that have been
assigned to Single-CO, Group-CO, Loop-CO, PDN or SDN.
Press NEXT. Dial 005.
<Extension Selection>
<Programming>
NEXT
Enter extension
number (3-4 digits).
Press STORE.
STORE
Press END.
END
extension no.
Enter button code. Press CO.
button code*
Enter parameters,
if required.
parameters*
<Programming>
<Cancelling>
SELECT
Press SELECT.
To continue
To end
To programme another extension
(CO)
<Cancelling>
Press STORE.
STORE
Enter 2. Press CO.
To continue
*Please refer to the table on the next page for information on “button code” and “parameters.”
2
0 0 5
(CO)