Philips Hi-Q Digital Video Recorders - Manual (Page 19)

7.4.1 Submenu <Alarms><<Inputs>>
NOTE: Use 1-Touch Alarm (front panel) to trigger alarm recording for the duration of the programmed POST
ALARM time. Continue alarm recording by pressing 1-Touch Alarm again.
7.4.2 Submenu <Alarms><<Outputs>>
7.5 Motion Detection
Motion detection causes the system to alarm based on motion through a zone. Sensitivity, speed, and direction
settings can be set via these menus.
19
F IELD V ALUES D EFAULT V ALUE
Auxiliary Alarm Input Polarity - • Normally Open Normally Open
Cameras 1– 4 individually • Normally Closed
Auxiliary Alarm Recording • Enabled Disabled
Follows Contact • Disabled
Pre-alarm Time [1 to 60 seconds] 30 seconds
Post-alarm Time:
Video Motion [1 to 60 minutes] 1 minute
Video Dark
Auxiliary
1 -Touch
F IELD V ALUES D EFAULT V ALUE
Warning Beep • Enabled Enabled
• Disabled
Relay Output Polarity - • Normally Open Normally Open
Cameras 1– 4 individually • Normally Closed
Relay Activation: [3 to 60 seconds, 5 seconds
Dwell Time - 1 second increments]
Cameras 1– 4 individually
Follows Mode for Aux Alarm - • Enabled Disabled
• Disabled