Philips Hi-Q Digital Video Recorders - Manual (Page 35)

APPENDIX B – Hi-Q DEFAULTS
35
I TEM F ACTORY D EFAULT V ALUE
Alarm Setup
Auxiliary Alarms All Disabled
Auxiliary Alarm Input Polarity All Normally Open
Relay Output Polarity All Normally Open
Relay Output Enable Disabled
Relay Activation Dwell Time 5 seconds
Relay Activation FOLLOWS Mode for Disabled
Contact Closure Alarms
1 -Touch Alarm Enabled
Dark Alarms All Disabled
Motion Detector Alarms All Disabled
Pre-alarm Recording Duration 30 Seconds
Post-alarm Recording Duration 1 Minute for All Alarm Types
Recording Setup
Video Recording All Continuous
Audio Recording Disabled
Estimated Recording Time Calculated
Image Quality Highest Quality
Time-lapse mode Real Time
Disk Full Behavior Overwrite; (Stop Recording with disk array)
Hard Drive: Data Redundancy For DVRRT4EP Model Only: Striping
Disk ( 1 , 2) Status Determined by System
Total Disk Capacity Calculated
Archive Mode Manual; (set to Stop Recording with disk array)
Motion Detector Setup
Target Size 2 h x 2 v
Motion Zones All Grid Elements Active
Sensitivity 70
Suppression Standard
Motion Detector Direction All ( 1 )
Target Speed 0– 40 seconds
Miscellaneous Setups
Profile Name Profile [Profile Number]
Warning Beeper Enabled
Front Panel Password Protection Disabled
Language Selection English
Date/Time On-screen Display Format 24-hour Mode; Not Affected by Restoring Factory Defaults
Activity Log Date/Time Current Date / Current Time – 5 Minutes
IP Address 1 0. 1 0.0.0
Subnet Mask 255.255.255.0
Default Router 1 0. 1 0.0. 1
Name of Hi-Q Hi-Qxxxx
Camera Titles Camera n, where n is the camera number < 1 ,2,3,4>
Brightness (Manual Gain) Adjustment on AUTO
Video Inputs (MON A Only)
Sequence Dwell Time - MON A & B 3 Seconds