Directed call pick-up, Directed call pick-up –19 – Polycom SIP 2.2.2 User Manual
Page 67
Configuring Your System
4 - 19
Configuration changes can performed centrally at the boot server or locally:
Directed Call Pick-Up
Calls to another phone can be picked up by dialing the extension of the other
phone. This feature depends on support from a SIP server.
Configuration changes can performed centrally at the boot server:
Note
Server-based call forwarding is disabled if Shared Call Appearance or Bridged Line
Appearance is enabled.
Central
(boot server)
Configuration file:
sip.cfg
Enable or disable server-based call forwarding.
•
For more information, refer to
on page
Configuration file:
phone1.cfg
Enable or disable server-based call forwarding as a per-registration
feature.
•
For more information, refer to
on page
Set all call diversion settings including a global forward-to contact and
individual settings for call forward all, call forward busy, call forward
no-answer, and call forward do-not-disturb.
•
For more information, refer to
on page
Local
Web Server
(if enabled)
Set all call diversion settings.
Navigate to: http://<phoneIPAddress>/reg.htm
Changes are saved to local flash and backed up to <Ethernet
address>-phone.cfg on the boot server. Changes will permanently
override global settings unless deleted through the Reset Local
Config menu selection and the <Ethernet address>-phone.cfg is
removed from the boot server.
Local Phone User
Interface
The user can set the call-forward-all setting from the idle display
(enable/disable and specify the forward-to contact) as well as divert
callers while the call is alerting.
Changes are saved to local flash and backed up to <Ethernet
address>-phone.cfg on the boot server. Changes will permanently
override global settings unless deleted through the Reset Local
Config menu selection and the <Ethernet address>-phone.cfg is
removed from the boot server.
Central
(boot server)
Configuration file:
sip.cfg
Turn this feature on or off.
•
For more information, refer to
.