Newcon Optik LRF MOD 4EC - Manual (Page 21)

18
Mode
Display name Dis
tance
Sp
eed
Azimuth Elev
ation
Retic
le
Targe
t
selection logic
Cd 16 Display test
Cd 17
Compass calibration
Gating GAt
Entrance into gating mode
Data
Recall
rEc
Recalls last 10 measurement sets
Data
Clearance
cLr
Clears all recorded data
Interface
format -PC-
or
PLGr
Selects PC or PLGR data format for output port
Empty field means the parameter is not measured in this mode, NC
means ‘no change’ to the measurement parameter setting
.
Once set, the mode parameter is stored in on-board memory and
will be kept current until reset in the Setup mode.
Choosing
Cd 16 in the Setup mode will cause all display
segments and indicators to flash for 8 seconds. Flashing can be
interrupted by pressing either button.