Nortel Networks NN43001-321 - Manual (Page 84)

84 Configuring MCS 5100
This is the HLOC + DN of the converged telephone. This number
is used for Click-to-Call in Converged Mode, and must be a UDP
number.
b. Enter 6139625573 in the Public Charge ID text box.
This is the NPA + NXX + DN of the converged telephone. It is the
caller identification information sent on a public call. This value is
required, and may be need even in Unconverged Mode.
c. Select cdCOS from the Class of Service drop-down list.
This is the same Class of Service configured in Procedure 5
"Configuring a route list" (page 75) .
Note: You do not have to configure an alias, but if you do,
ensure that it does not conflict with the alias properties
configured in
Step 3 .
d. Click Save.
3 Set up the converged properties, as follows:
a. Click Converged Desktop properties.
The Converged Desktop Data web page opens, as shown in
Figure 35 "Provisioning Client: Converged Desktop Data" (page
84)
.
Figure 35
Provisioning Client: Converged Desktop Data
b. Enter 000023345573 in the Converged Desktop Alias text box.
This is the PNI + HLOC + DN of the converged telephone.
c. Enter one of the following values in the Converged Desktop
Preferred Audio Device text box:
• If you are configuring UDP, enter the Access Code (AC1 or
AC2) + HLOC + DN of the converged telephone.
Nortel Communication Server 1000
Communication Server 1000 to MCS 5100 Converged Desktop Type 2 Configuration Guide
NN43001-321 01.05 Standard
Release 5.0 15 February 2008
Copyright © 2005-2008, Nortel Networks
.