NordicTrack GRT500 - Manual (Page 6)

6
1.
Open the parts bag labeled ÒFRAME ASSEMBLY.Ó
Press a 2Ó Square Inner Cap (33) and a 2Ó x 3Ó Inner
Cap (24) into the Main Upright (3) in the indicated
locations.
Press a 2Ó x 3Ó Inner Cap (24) into each end of the
Stabilizer (5).
Attach the Stabilizer (5) to the Main Upright (3) with
two 3/8Ó x 3 3/4Ó Carriage Bolts (52) and two 3/8Ó
Nylon Locknuts (50). Do not tighten the Nylon
Locknuts yet.
1 Frame Assembly
33
24
24
5
50
Support Tube
24
3
52
2. Press 2Ó Square Inner Caps (33) into the Leg Lever
(29) and the front leg on the Base (8) as shown.
Align the bracket on the Base (8) with the three holes
in the Main Upright (3). Attach the Base with a 3/8Ó x
4Ó Bolt (65), a 3/8Ó Flat Washer (55), and a 3/8Ó Nylon
Locknut (50). The Bolt must be inserted from the
side shown. Do not tighten the Nylon Locknut yet.
Next, insert two 5/16Ó x 3Ó Bolts (78) into the Base (8)
and the Main Upright (3) and finger tighten a 5/16Ó
Nylon Locknut (21) onto each Bolt. Do not tighten
the Nylon Locknuts yet.
Before beginning assembly, make sure you
have read and understood the information on
page 5. This brief introduction will save you
much more time than it takes to read it!
2
65
50 55
78
33
29
8
Front Leg
Bracket
3
21
3
3. Attach the Leg Lever Lock (11) to the front leg with a
5/16Ó x 3Ó Bolt (78), three 5/16Ó Flat Washers (80) and
a 5/16Ó Nylon Locknut (21). Do not overtighten the
Nylon Locknut; the Leg Lever Lock must pivot
easily.
Attach the Foot Plate (4) to the Base (8) with a 3/8Ó x
5 1/2Ó Bolt (57) and a 3/8Ó Nylon Jamnut (63).
78
11
80
80
21
Front
Leg
57
4
8
63