NISSAN 2010 Z Coupe - Manual (Page 392)

Black plate (394,1)
Model "Z34-D" EDITED: 2009/ 9/ 10
7. Insert a flat-blade screwdriver into the
grommet hole to add a 90 8 turn onto the
part
*
E .
8. Insert a J-nut into the license plate bracket
before placing the license plate bracket on
the fascia.
9. Install the license plate bracket with the
screws.
10. Install the license plate with bolts that are
not longer than 0.55 in (14 mm).
When the recovery hook is used, you need to
temporarily remove the front license plate and
bracket from the vehicle. (See “VEHICLE
RECOVERY (freeing a stuck vehicle)” in the
“6. In case of emergency” section for further
details.)
STI0623
Left side
This vehicle is equipped with air deflectors in
front of the front wheels. The deflectors will
change the air flow to help improve aerodynamic
performance.
When transporting your vehicle on a trailer, the
air deflectors may interfere with a steep slope to
a trailer bed. In this case, remove the deflectors
from the undercover of the vehicle.
1. Loosen three screws as shown and remove
the left-side air deflector
*
A .
2. Tighten the removed screw
*
B in its
original position.
3. Perform the same procedure to remove the
right-side air deflector.
4. Store the two air deflectors and four screws
to reinstall in the reverse order.
5. When reinstalling, make sure all six screws
are firmly tightened on both air deflectors.
REMOVING AIR DEFLECTORS
(except for NISMO models)
9-16 Technical and consumer information