Dg834g v5 with fqdn to fvl328, Configuration profile – NETGEAR 54 Mbps Wireless ADSL Firewall DG834G User Manual
Page 156
Wireless ADSL2+ Modem Router DG834G User Manual
B-6
NETGEAR VPN Configuration
v1.0, May 2008
DG834G v5 with FQDN to FVL328
This section is a case study on how to configure a VPN tunnel from a NETGEAR DG834G v5 to a
FVL328 using a fully qualified domain name (FQDN) to resolve the public address of one or both
routers. This case study follows the VPN Consortium interoperability profile guidelines (found at
).
Configuration Profile
The configuration in this section follows the addressing and configuration mechanics defined by
the VPN Consortium. Gather all the necessary information before you begin the configuration
process. Verify that the firmware is up to date, and that you have all the addresses that will be
necessary, and all of the parameters that need to be set on both sides. Check that there are no
firewall restrictions.
Table B-2. Profile Summary
VPN Consortium Scenario:
Scenario 1
Type of VPN
LAN-to-LAN or Gateway-to-Gateway (not PC/Client-to-Gateway)
Security Scheme:
IKE with Preshared Secret/Key (not Certificate-based)
IP Addressing:
NETGEAR-Gateway A
Fully Qualified Domain Name (FQDN)
NETGEAR-Gateway B
FDQN
Figure B-6