Configuration summary (telecommuter example) – NETGEAR 54 Mbps Wireless ADSL Firewall DG834G User Manual
Page 161
Wireless ADSL2+ Modem Router DG834G User Manual
NETGEAR VPN Configuration
B-11
v1.0, May 2008
6. Test the VPN tunnel by pinging the remote network from a PC attached to the DG834G v5.
a. Open the command prompt (Start -> Run -> cmd)
b. Type ping 172.23.9.1
Configuration Summary (Telecommuter Example)
The configuration in this section follows the addressing and configuration mechanics defined by
the VPN Consortium. Gather all the necessary information before you begin the configuration
process. Verify whether the firmware is up to date, all of the addresses that will be necessary, and
all of the parameters that need to be set on both sides. Assure that there are no firewall restrictions.
Figure B-12
Note: The pings might fail the first time. If this happens, try the pings a second
time.
Table B-3. Configuration Summary (Telecommuter Example)
VPN Consortium Scenario:
Scenario 1
Type of VPN:
PC/client-to-gateway, with client behind NAT router
Security Scheme:
IKE with Pre-shared Secret/Key (not certificate-based)
IP Addressing:
Gateway
Fully Qualified Domain Name (FQDN)
Client Dynamic