Nortel Networks NORSTAR P0886634 - Manual (Page 25)

Installing the DFC on systems equipped with a BIC 19
P0886634 Issue 1.0 FAX Installation Guide
Figure 13 Disconnecting the Serial Ports A and B and the keyboard/mouse connector
6. Locate the BIC and disconnect the fiber cable.The BIC is located in Slot 2 of
the NAM II and in Slot 4 of the new NAM.
7. Remove the slot cover screw.
8. Use both hands to carefully hold the BIC along the top. Lift the BIC straight
up and out from the module. Sometimes the BIC is tightly seated and difficult
to remove. You may need to wiggle it out with a slight rocking motion.
Installing the Media Services Bus Expansion Card (BEC) on the BIC
A Media Services Bus Expansion Card (BEC) Type A is a daughterboard that is
installed on the BIC provides the BIC with the ability to connect to a Digital Fax
Card (DFC).
Before you begin the installation, you must have #2 Phillips screwdriver.
To install the BEC:
1. Ground yourself by attaching one end of the grounding strap to your wrist and
the other end to a grounded metal surface.
Serial Port A Connector
Serial Port B Connector
Keyboard/mouse
Connector
Keyboard/mouse
backplane connector