Gps receiver, Receiver, 2 gps receiver – Navigon MobileNavigator 5 User Manual

Page 125

Advertising
background image

User's manual MobileNavigator | 5

Appendix

- 123 -

9.2.2 GPS receiver

Possible error
sources concerning

the initialisation of
the GPS receiver

If the GPS symbol stays red (no GPS-reception) even though the
system has been installed correctly, this may be due to one of

the following reasons:

Ù Reason A: an incorrect COM-port is selected.

Ù Reason B: the receiver is not supplied with power.

A

The GPS receiver is connected to another COM-port than COM 1.

1. On the main screen, tap the Configuration button.

The C

ONFIGURATION

screen opens.

2. Via the arrow buttons, select GPS.

3. Tap Automatic detection when you have reconnected or

changed your GPS-receiver. Follow the instructions on the

screen.

4. Tap Manual settings when automatic detection is not

successful. Set the following values:

5. Tap the COM-port field.
6. Select another COM-port.

When the GPS symbol becomes green, you may start
navigation.

B

The cigarette-lighter is not permanently supplied with power.
If the GPS symbol stays red (no GPS-reception) even though you
have tried all available COM-ports, it may be that your cigarette-
lighter is not permanently supplied with power.

1. Quit MobileNavigator.
2. Start your engine.
3. Restart MobileNavigator.

4. The GPS receiver should now be ready for use within short

time (the GPS symbol becomes green). In the future, start
your vehicle before starting the navigation software.

The GPS receiver
takes long to be

ready to use

The GPS receiver has a battery which maintains saving data
collected during the initialisation process.
Once the initialisation has been executed successfully, there is
two modes of starting the GPS receiver up:
Mode 1

takes about 5 to 6 minutes. The GPS receiver has

not been used for at least one week.

Mode 2

takes about 1 to 2 minutes. The GPS receiver has

been used almost daily.

Advertising