Nortel Networks T7406 - Manual (Page 10)

10 Chapter 1 About your T7406 Phone
NN40110-300 NN40110-300
Mounting Bracket
T7406 Pre-installation Programming
Before connecting the T7406 base station to your system, you must set up system programming
for the handset lines.
Have the system administrator set up this programming:
1 Program Handsfree to Auto.
2 Program a maximum of three lines to each handset.
3 Assign Ring & Appear on the lines you assign to the handset.
4 Set the Page zone to None.
5 Set DND on Busy to Yes if you do not want your calls interrupted with a ring tone when a
second call comes in. Instead, the button flashes, indicating an incoming call.
6 Other telephone programming is the same as for the M7310 telephone, with the exception of
the memory key locations.
Before you start
• Ensure there is an AC power outlet within 1.5 meters (5 feet) of the base station location.
Note: Appear only does not allow the handset to wake from Handset Asleep
mode.
Note: Handsets can send Page announcements, but they cannot receive them.
Mounting
bracket
Notches match to bracket.