Nortel Networks T7406 - Manual (Page 21)

Chapter 1 About your T7406 Phone 21
T7406 Cordless Handset Installation Guide
Ring Selection
You can accept or block calls from ringing at your handset using the Allow calls feature. When
you receive a call and the Allow calls feature is OFF, line buttons and the light collar flash but the
call does not ring.
To assign the ring selection:
1 Press the Options button.
2 Press SHOW .
3 Press NEXT three times.
The display shows 4. Ring Selection .
4 Press SHOW .
The display shows Allow Calls .
5 Press OFF to prevent calls from ringing at the handset.
Do not disturb appears on the displays when the Allow calls feature is OFF.
Note: Press
ON to allow calls to ring at the handset.
6 Press the Options button.
The display changes to show the date and time.
Setting Handset Features
After you identify the handsets to the base station, you can set up the handset features:
Ring Type
To assign the ring type:
1 Press the Options button.
2 Press SHOW .
The display shows 1. Ring Type .
3 Press SHOW . The display shows Ring Type :1 .
4 There is also a Ringer Off setting.
5 Press CHANGE to listen to the four different rings available on your handset.
6 Press OK to accept the ring type of your choice.
7 Press the Options button to exit the Option menu.
The display changes to show the date and time.
Note: Ring Type can only be set through the Option menu on the handset. This
feature cannot be set in system programming.