Nortel Networks T7406 - Manual (Page 44)

44 Chapter 4 Regulatory information
NN40110-300 NN40110-300
Nortel Networks
640 Massman Drive,
Nashville, TN, 37210
USA
Hearing aids: This telephone is compatible with hearing aids equipped with an appropriate
telecoil option.
Programming emergency numbers: When programming emergency numbers and/or making
test calls to emergency numbers:
1 Remain on the line and briefly explain to the dispatcher the reason for calling before hanging
up.
2 Perform such activities in the off-peak hours, such as early mornings or late evenings.
EMI/EMC (FCC Part 15)
Privacy of communications may not be assured when using this phone.
Changes or modifications not expressly approved by the party responsible for compliance could
void the user’s authority to operate the equipment.
For Class A Host equipment
This equipment has been tested and found to comply with the limits for a Class A digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a commercial environment.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause harmful interference in which
case the user will be required to correct the interference at his own expense.
For Class B Host equipment
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation.
Note: This device complies with Class A EMI requirements when connected to
host equipment that meets Class A and Class B when connected to host equipment
that meets Class B. Consult the System Installation Guide for the applicable
compliance.