Verifying tcp/ip properties, Configuring a macintosh for tcp/ip networking, Configuring macos 8.6 or 9.x for tcp/ip networking – NETGEAR DM602 User Manual
Page 30: Verifying tcp/ip properties -6, Configuring a macintosh for tcp/ip networking -6
Reference Manual for the Model DM602 ADSL Modem
3-6
Preparing Your Computer
7.
Click OK and close all Network and Dialup Connections windows.
8.
Make sure your PC is connected to the modem, then reboot your PC.
Verifying TCP/IP Properties
To check your PC’s TCP/IP configuration:
1.
On the Windows taskbar, click the Start button, and then click Run.
The Run window opens.
2.
Type
cmd
and then click OK.
A command window opens
3.
Type
ipconfig /all
Your IP Configuration information will be listed, and should match the values below if you are
using the default TCP/IP settings that NETGEAR recommends:
•
IP addresses—192.168.0.2 through 192.168.0.253
•
The subnet mask is 255.255.255.0
•
The default gateway is 192.168.0.1
4.
Type
exit
Configuring A Macintosh for TCP/IP Networking
Beginning with Macintosh Operating System 7, TCP/IP is already installed on the Macintosh. On
the Macintosh, you will need to configure TCP/IP to use DHCP.
Configuring MacOS 8.6 or 9.x for TCP/IP Networking
1.
From the Apple menu, select Control Panels, then TCP/IP.
DM602.book Page 6 Friday, October 4, 2002 4:22 PM