NETGEAR DM602 - Manual (Page 42)

Reference Manual for the Model DM602 ADSL Modem
5-2 Advanced Configuration of the Modem
This screen shows the following parameters:
Table 5-1. Router Status Fields
Field Description
Firmware Version This field displays the modem firmware version.
LAN Port These IP parameters apply to the Local Area Network (LAN) of the
modem.
MAC Address This field displays the Ethernet MAC address being used by the LAN
port of the modem.
IP Address This field displays the IP address being used by the ADSL (WAN) port of
the modem. If no address is shown, the modem cannot connect to the
Internet.
IP Subnet Mask This field displays the IP Subnet Mask being used by the ADSL(WAN)
port of the modem.
Modem These parameters apply to the ADSL modem section of the modem.
ADSL Firmware Version This field displays the ADSL chipset firmware version.
Modem Status This field displays the state of the ADSL connection to your service
provider, either “Connecting” or “Connected”
Connect Mode This field displays the protocol used to connect to your service provider.
When the ADSL link comes up, the connection will be either “Fast” or
“Interleaved”, depending on the way the telephone company has
configured its equipment
Down Stream This field displays the connection rate from the service provider to the
modem in bits per second
Up Stream This field displays the connection rate from the modem to the service
provider in bits per second
VPI This field displays the VPI entered in the Setup Wizard or Basic Settings
screen
VCI This field displays the VCI entered in the Setup Wizard or Basic Settings
screen
DM602.book Page 2 Friday, October 4, 2002 4:22 PM