Chapter 3 basic installation and configuration, Overview of wireless usb print server setup, Wgps606 default factory settings – NETGEAR WGPS606 User Manual
Page 17: Chapter 3, Basic installation and configuration, Overview of wireless usb print server setup -1, Wgps606 default factory settings -1
Advertising
Basic Installation and Configuration
3-1
202-10083-01
Chapter 3
Basic Installation and Configuration
This chapter describes how to install your NETGEAR 54 Mbps Wireless USB Print Server with
4-Port Switch WGPS606 and set up basic connectivity on your Local Area Network (LAN).
Overview of Wireless USB Print Server Setup
Figure 3-1: Network overview
When you finish the installation, your network will resemble this illustration.
WGPS606 Default Factory Settings
When you first receive your WGPS606, the default factory settings are shown below. You can
restore these defaults with the Factory Default Restore button on the rear panel as explained in
“How to Restore the Factory Default Settings” on page 2-6
.
7'03
0RINTER
0RINTER
53"
53"
$ESKTOP
Advertising