NETGEAR WGPS606 - Manual (Page 30)

Reference Manual for the NETGEAR 54 Mbps Wireless USB Print Server with 4-Port Switch
4-4 Management
202-10083-01
Figure 4-2: WGPS606 Upgrade Firmware page
2. From the main menu Maintenance section, click the Upgrade Firmware link to display the
screen above.
3. Click Browse and locate the image upgrade file.
4. Click Upgrade.
When the upload completes, your wireless USB print server will automatically restart. The
upgrade process typically takes about one minute.
In some cases, you may need to reconfigure the wireless USB print server after upgrading. You
can click the Status link to check the Firmware Version and verify that your wireless USB print
server now has the new firmware installed.
Restoring Factory Default Settings
It is sometimes desirable to restore the wireless USB print server to the factory default settings.
This can be done by using the Erase button in the Backup Settings menu, which restores all factory
default settings. Be sure to back up your settings before restoring the factory defaults.
After a restore, the password will be password, the DHCP client is enabled, the WGPS606
defaults to the LAN IP address of 192.168.0.102 when there is no DHCP server.
Using the Reset Button to Reboot or Restore Factory Defaults
To restore the factory default configuration settings, you use the Default Reset button on the rear
panel of the wireless USB print server. The reset button has two functions:
• Reboot. When pressed and released quickly, the wireless USB print server will reboot
(restart).