Changing the administrator password, Changing the administrator password -5 – NETGEAR WGPS606 User Manual
Page 31
Reference Manual for the NETGEAR 54 Mbps Wireless USB Print Server with 4-Port Switch
Management
4-5
202-10083-01
•
Reset to Factory Defaults. This button can also be used to clear all data and restore all
settings to the factory default values, when held down longer.
To clear all data and restore the factory default values:
1.
Use something with a small point, such as a pen, to press the Reset button in for at least 10
seconds.
2.
The power light will turn yellow and blink.
3.
Release the Reset button.
The factory default configuration has now been restored, and the WGPS606 is ready for use.
Changing the Administrator Password
The default password is password. Change this password to a more secure password. You cannot
change the administrator login name.
From the main menu of the browser interface, under the Maintenance heading, click Change
Password to bring up the page shown below.
Figure 4-3: Set Password page
To change the password, first enter the old password, and then enter the new password twice. Click
Apply to save your change.