Neuton MA 3.0 - Manual (Page 12)

8 NEUTON MA 3.0 Cordless Electric Trimmer Safety & Operating Instructions
Attaching and Removing the Trimmer
Attaching and removing your Trimmer is quick and easy; just a few simple steps.
Attaching the Trimmer
When attaching the Trimmer, it is easiest to have
the housing in edge mode and have the head
turned up (position 4). This assures that the
Trimmer head is out of the way and will not hit
the ground when sliding into position. (Please
refer to “Adjusting the Trimmer” on page 9 for
details on adjusting the Trimmer housing and
head.)
1. If attaching the Trimmer to your Mower,
adjust the cutting height lever to position 6,
setting the cutting height to its highest level.
2. Slide the Trimmer posts into the slots in the
front of the Mower or Power Pod (Figure 4).
The posts snap into place when properly attached.
Removing the Trimmer
1. Hold the Trimmer posts and push down
the orange release button with your right
thumb (Figure 5).
2. Slide the Trimmer out of position. Once it
has started to slide out, you can release the
orange button.
Figure 4. Attaching the Trimmer
Figure 5. Push down the orange button to
remove the trimmer
Orange release button