Neuton MA 3.0 - Manual (Page 13)

NEUTON MA 3.0 Cordless Electric Trimmer Safety & Operating Instructions 9
Adjusting the Trimmer
Before adjusting your Trimmer, you must first
decide to edge or trim your lawn. Then you must
decide the angle to use that will best accomplish
the job.
■
You set the trimmer housing for edging or
trimming.
■
You set the trimmer head for the angle of
the cut.
Make sure that both the housing and head (Figure
6) have been set to the proper positions — set
for either trimming or edging, and set to the proper cutting angle — before using your Trimmer.
Please review Figures 7 through 10 to become familiar with the parts and settings of your Trimmer.
This will help you better understand the instructions for positioning your Trimmer.
Setting the Trimmer Housing
The Trimmer housing has two clearly marked
settings: one for trim and one for edge (Figure 7).
(This figure also shows the position marks for
setting the cutting angle).
You can set the Trimmer housing to any of these
clearly marked positions:
■
Trim on the right side as you push.
■
Trim on the left side as you push.
■
Edge on the right side (only) as you push.
(The Trimmer cannot be set to edge on the
left side.)
Switch between the Edge and two Trim positions
to set the housing to the proper setting.
1. Squeeze the orange housing rotation bar and
hold it (Figure 8).
2. Begin to twist the housing to the desired
position.
3. Release the handle when you reach the
desired position. The housing locks into the
setting position.
Make sure the housing snaps securely into place.
Figure 6. Parts of the Trimmer
Figure 7. Trimmer setting: Trim or Edge on the
body; Cutting angle positions on the head
Figure 8. Squeeze the orange handle to adjust
the body to trim or edge
Head
Orange housing
rotation bar
Orange
release
button
Housing
Mounting
posts
Orange head
rotation button
(hidden)
Position marks