Neuton MA 3.0 - Manual (Page 14)

10 NEUTON MA 3.0 Cordless Electric Trimmer Safety & Operating Instructions
Setting the Trimmer Head
The Trimmer head sets the cutting angle for trimming or edging. The head has one setting for
trimming and three settings for edging. To set the head, simply twist it to the desired position.
You can set the Trimmer head to any of these clearly marked positions:
■
Trimming: Position 1
■
Edging horizontally: Position 2
■
Edging at a 45 degree angle: Position 3
■
Edging vertically: Position 4
You can rotate among the four Trimmer head
settings.
1. Pull the orange head rotation button and hold
it (Figure 9).
2. Begin to twist the head to the position for the
desired cutting angle.
3. Release the button when you reach the
desired cutting position. The head locks into
the position.
Make sure the head snaps securely into place.
To trim on the left side, rotate the trimmer head 180° then set the trimmer housing to right trim.
(Please refer to Figure 10-Rotate and Figure 10-Left Trim on the next page.)
Figure 9. Pull the orange head rotation button
to twist the head to the cutting position
Orange head
rotation button