Gpib-com components, Address decoding, Configuration jumpers – National Instruments GPIB-COM User Manual

Page 23: Ins8250a compatible registers, Gpib acceptor and source handshaking, Mode control logic, Interrupt control logic

Advertising
background image

Section Three

Function Description

© National Instruments Corporation

3-3

GPIB-COM User Manual

GPIB-COM Components

The interface consists of the following functional components:

•

Address Decoding

•

Configuration Jumpers

•

INS8250A Compatible Registers

•

GPIB Acceptor and Source Handshaking

•

Mode Control Logic

•

Interrupt Control Logic

•

Direction Buffers

•

GPIB Transceivers

Address Decoding

Address decoding monitors the PC address bus to recognize when a GPIB-COM address is
present and enables a read and/or write to its registers.

Configuration Jumpers

These onboard jumpers select the base address, GPIB controller mode, and interrupt request line
used by the GPIB-COM.

INS8250A Compatible Registers

The main component of an IBM PC compatible serial adapter is an INS8250A Asynchronous
Communications chip or its equivalent, which handles RS-232 communication. The INS8250A
compatible registers on the GPIB-COM emulate the serial adapter registers so that the GPIB-
COM will operate transparently with any serial port driver.

GPIB Acceptor and Source Handshaking

This circuitry converts PC serial port handshaking into GPIB handshaking. This process is
completely software-transparent.

Mode Control Logic

This circuitry determines whether the GPIB-COM should be a Talker (and the target device a
Listener) or a Listener (and the target device a Talker).

Interrupt Control Logic

This circuitry generates and masks interrupts on GPIB conditions which correspond to the
conditions that would cause the INS8250A circuit to generate an interrupt.

Advertising