NordicTrack NTL21905.2 - Manual (Page 26)

26
HOW TO OPERATE THE PERSONAL TELEVISION
IMPORTANT: Before operating the television, you
must connect a 75 ohm CATV cable or a VCR to the
75 ohm terminal on the treadmill. See page 11 for
instructions.
Follow the steps below to operate the television.
Insert the key into the console.
See HOW TO TURN ON THE POWER on page
15.
Press the Power button to turn on the
television.
When the key is inserted, the television will auto-
matically turn on. If you have turned off the televi-
sion, turn it on by pressing the Power button.
Press the Channel buttons to select the
desired cable channel.
Note: Complete this step only if you are using
analog cable. Otherwise, change channels
through an external source such as your cable
box or your VCR.
When the television is turned on, the screen will
show the last cable channel that was selected. To
select a different channel, press the Channel but-
tons. The selected channel number will appear on
the screen for a few seconds. Note: The television
is equipped with a channel memorizing function
that allows you to go directly from the current chan-
nel to the next channel saved in memory. Before
channels can be selected in this way, they must be
saved in the television’s memory. See HOW TO
USE THE TV SETTINGS MODE on this page.
Press the Volume buttons to adjust the volume.
When either Volume button is pressed, the vol-
ume level indicator will appear on the screen for a
few seconds. Note: When the iFIT mode is se-
lected, the Volume buttons will control the volume
of the audio of the iFIT program.
To use earphones or headphones (not included),
plug them into the headphone jack on the console.
When you are finished using the television,
press the Power button.
Press the Power button to turn off the television.
Note: Removing the key from the console will also
turn off the television.
HOW TO USE THE TV SETTINGS MODE
The console features a TV settings mode that allows
you to adjust the settings of the television and to save
channels into the television’s memory.
Follow the steps below to use the TV settings mode.
Select the TV settings mode.
To select the TV settings mode, first select the set-
tings mode by holding down the Stop button while
inserting the key into the console. (The TV settings
mode will be selected when you press the Power
button in step 2.)
Press the Power button to add or delete
channels.
Note: Complete this step only if you are using
analog cable.
After all valid cable channels available in your
area have been saved into the television’s mem-
ory (see step 4 on the following page), you can
manually add channels or delete unwanted chan-
nels.
To add or delete a cable channel, first press the
Channel buttons until the desired channel number
appears on the screen. Then, press the Volume
increase button to add the channel, or the Volume
decrease button to delete the channel. Continue
this process until you have added all desired
channels and deleted all unwanted channels.
Press the Power button again and select a
cable connection.
If you have connected a CATV cable, one of the
three Cable settings should be selected; try all
three Cable settings, if necessary, to find the opti-
mal setting. Press the Volume increase button to
select the Standard Cable setting, the Channel
decrease button to select the Cable IRC setting,
or the Channel increase button to select the Cable
HRC setting. Note: The setting that you select will
not appear on the screen.
If you are viewing channels through an external
source such as a cable box or a VCR, the televi-
sion will save only the channel used by the exter-
nal source.
3
2
1
5
4
3
2
1