Nexgrill 720-0600 - Manual (Page 5)

5
LP-Gas Supply System
§If the information is not followed exactly, a fire resulting in death or
serious injury could occur.
§A 20lb tank of approximately 12 inches in diameter by 18-1/4 inches
high is the maximum size LP gas tank to use.
§This safety feature prevents the tank from being overfilled, which
can cause malfunction of the LP gas tank, regulator and/or grill.
§The LP gas supply cylinder to be used must be constructed and
marked in accordance with the specifications for LP
–Gas cylinder of
the U.S. Department of Transportation (DOT) or the National
Standard of Canada ,CAN/CSA
–B339, Cylinders, Spheres and
Tubes for Transportation of Dangerous Goods and Commission .
§The LP gas tank must have a shutoff valve terminating in an LP
valve outlet that is compatible with a Type 1. LP gas supply cylinder
must have a shut off valve terminating in a valve outlet specified for
connection type QCC1 in the standard for compressed gas cylinder
valve outlet and inlet connection ANSI/CGA-V-1 as applicable. LP
gas supply cylinder must be fitted with an Overfill Protection Device
(O.P.D) The LP gas tank must also have a safety relief device that
has a direct connection with the vapor space of the tank.
§The tank supply system must be arranged for vapor withdrawal.
§The LP gas tank used must have a collar to protect the tank valve
§Place dust cap on cylinder valve outlet whenever the cylinder is not
in use. Only install the type of dust cap on the cylinder valve outlet
that is provided wit the cylinder valve. Other types of cap or plugs
may result in leakage of propane
§Never connect an unregulated LP gas tank to your gas grill.
§This outdoor cooking gas appliance is equipped with a high capacity
hose/regulator assembly for connection to a standard 20lb. Liquid
propane cylinder.
§Have your LP gas tank filled by a reputable propane gas
dealer and visually inspected and re-qualified at each filling.
§ Do not store a spare LP gas cylinder under or near this
appliance.
§ Never fill the cylinder beyond 80 percent full .
§Always keep LP gas tanks in an upright position.
§Do not store or use gasoline or other flammable vapors and liquids
in the vicinity of this or any other appliance.
§Storage of an outdoor cooking gas appliance indoors is permissible
only if the cylinder is disconnected and removed from the outdoor
cooking gas appliance..
§When your gas grill is not in use the gas must be turned off at LP
gas tank.
•The gas must be turned off at the supply cylinder when the outdoor
cooking gas appliance is not in use.
•LP gas tank must be stored outdoors in a well-ventilated area and
out of reach of children. Disconnected LP gas tanks must not be
stored in a building, garage or any other enclosed area.
PROPER PLACEMENT AND CLEARANCE OF
GRILL
•Never use your gas grill in a garage, porch, shed,
breezeway or any other enclosed area. Your gas grill is
to be used outdoors only.
•Do Not install this unit into combustible enclosures.
•Minimum clearance from sides and back of unit to
combustible construction, 24 inches (61cm) from sides
and 24 inches (61cm) from back.
•DO NOT use this appliance under overhead
combustible surfaces. This outdoors cooking gas
appliance is not intend to be installed in or on
recreational vehicles and/or boats.
•Do Not obstruct the flow of ventilation air around the
gas grill housing. Only use the regulator and the hose
assembly supplied with your gas grill. Replacement
regulators and hose assemblies must be those specified
in this manual.
•The regulator and hose assembly must be inspected
before each use of the grill. If there is excessive
abrasion or wear or if the hose is cut, it must be
replaced prior to the grill being put into operation. The
replacement hose assembly shall be that specified by
the manufacturer.
•Pressure regulator and hose assembly supplied with
the outdoor cooking gas appliance must be used. Never
substitute other types of regulator. Contact customer
service for manufacturer specified replacement parts.
•This outdoor cooking gas appliance is equipped with a
pressure regulator comply with the standard for
Pressure Regulating Valves for LP Gas ANSI/ UL 144.
•Do not use briquettes of any kind in the grill.
•The grill is designed for optimum performance without
the use of briquettes. Do not place briquettes on the
radiant as this will block off the area for the grill burners
to vent. Adding briquettes can damage ignition
components and knobs, and void the warranty.
•Keep the back and side cart free and clear from debris.
Keep any electrical supply cord, or the rotisserie motor
cord away from the heated areas of the grill.
•Never use the grill in extremely windy conditions. If
located in a consistently windy area (oceanfront,
mountaintop, etc.) a windbreak will be required. Always
adhere to the specified clearance.
•Never use a dented or rusty propane tank.
•Keep any electrical supply cord and the fuel supply
hose away from any heated surface
•While lighting, keep your face and hands as far away
from the grill as possible.
•Burner adjustment should only be performed after the
burner have cooled.
Safety Instruction
continued