Nikon S51c - Manual (Page 8)

vi
Notices
In
trodu
ct
ion
FCC/IC RF Exposure Statement
The available scientific evidence
does not show that any health
problems are associated with using
low power wireless devices. There is
no proof, however, that these low
power wireless devices are
absolutely safe. Low power wireless
devices emit low levels of radio
frequency energy (RF) in the
microwave range while being used.
Whereas high levels of RF can
produce health effects (by heating
tissue), exposure to low-level RF that
does not produce heating effects
causes no known adverse health
effects. Many studies of low-level RF
exposures have not found any
biological effects. Some studies have
suggested that some biological
effects might occur, but such
findings have not been confirmed
by additional research. Wireless LAN
Module (GC-131) has been tested
and found to comply with FCC/IC
radiation exposure limits set forth
for an uncontrolled equipment and
meets the FCC radio frequency (RF)
Exposure Guidelines in Supplement
C to OET65 and RSS-102 of the IC
radio frequency (RF) Exposure rules.
Please refer to the SAR test report
that was uploaded at FCC website.
This device should not be co-located
or operated in conjunction with any
other antenna or transmitter. Notice for customers in the
U.S.A.
FCC RF Interference Statement
This equipment has been tested and
found to comply with the limits for a
Class B digital device, pursuant to
Part 15 of the FCC rules. These
limits are designed to provide
reasonable protection against
harmful interference in a residential
installation. This equipment
generates, uses, and can radiate
radio frequency energy and, if not
installed and used in accordance
with the instructions, may cause
harmful interference to radio
communications. However, there is
no guarantee that interference will
not occur in a particular installation.
If this equipment does cause
harmful interference to radio or
television reception, which can be
determined by turning the
equipment off and on, the user is
encouraged to try to correct the
interference by one or more of the
following measures:
• Reorient or relocate the receiving
antenna.
• Increase the separation between
the equipment and receiver.
• Connect the equipment into an
outlet on a circuit different from
that to which the receiver is
connected.
• Consult the dealer or an
experienced radio/television
technician for help.