NordicTrack N150 User Manual
Page 24
ADSL2+ Wireless N150 Modem Router User Guide
YML14WN
24
www.netcomm.com.au
LAN
DNS
Go to Interface -> LAN to enable DHCP server. You can then set DNS server for the router. A Domain Name System (DNS) server is like
an index of IP addresses and Web addresses. If you type a Web address into your browser, a DNS server will find that name in its index
and find the matching IP address.
Most ISPs provide a DNS server for speed and convenience. Since your Service Provider may connect to the Internet with dynamic IP
settings, it is likely that the DNS server IP addresses are also provided dynamically. However, if there is a DNS server that you would
rather use, you need to specify the IP address below.
LAN Configuration
The ‘LAN Settings’ option enables you to configure the LAN port.
If DHCP Relay is selected, the DHCP requests from local PCs are forward to the DHCP server that runs on the WAN side. To have this
function working properly, disable the NAT to run on router mode only, disable the DHCP server on the LAN port, and make sure the
routing table has the correct routing entry.